Category: Engineering

Numerical simulation using Aspen plus Write a short project report for the engineers at ABC Chemicals documenting your findings. It should include the following information: Criteria for optimization Proposed system design (reactor type, reactor + separator + ??, how connected? feed, product, recycle streams? Explain and justify your design compared to other alternatives – no…

Did you find any examples of greenwashing? Which type of greenwashing?

May 6, 2023

—

by

Final Paper PAPER INTRODUCTION This final paper is in place of a final exam for this class. It is an individual assignment. Follow the link https://about.nike.com/en/newsroom/reports/fy22-nike-inc-impact-report to the Corporate Social Responsibility (CSR) report of an American Fortune 500 company. Your assignment is to read all the sections that focus on various aspects of the…

Identify a real life process and produce a presentation (about 20 pages in PowerPoint) or a written report (5 pages single space) covering the following aspects: Process description.

Apr 28, 2023

—

by

Lean Six Sigma Project Description The final project for this class requires students to identify a real life process and produce a presentation (about 20 pages in PowerPoint) or a written report (5 pages single space) covering the following aspects: Process description. Lean Six Sigma Tool(s) applied. Results or expected results. Any other information that…

Can one of the 11-groups be considered a Reynolds number?

Apr 27, 2023

—

by

Homework 6 The period of a pendulum, T, is assumed (correctly or incorrectly) to depend on its mass, M, the length of the pendulum. P, the acceleration due to gravity, 9, and the angle of swing, O. Using dimensional analysis, nondimensionalize the period, T, and express its dependence on the other non-dimensional terms. Under certain…

Determine the combined critical speed of shaft in HW 06 problem 1 using Dunkerley’s equation. Assume uniform diameter of 1.3in throughout.

—

by

MEE 342 – Principles of Mechanical Design Determine the combined critical speed of shaft in HW 06 problem 1 using Dunkerley’s equation. Assume uniform diameter of 1.3in throughout. 2. Determine the combined critical speed of shaft in HW 06 problem 2 using Dunkerley’s equation. Assume constant diameter throughout. If the operating speed is unsafe, suggest…

Identify what is unknown and create property calls or additional equations to get that information.

—

by

Engineering Equation Solver (EES) code to solve problem Create a code to solve the following problem in EES. Use property calls to get enthalpies or other data that would usually be looked up in the tables. Problem Statement: A simple ideal Rankine cycle with water as the working fluid operates between the pressure limits of…

Calculate the theoretical efficiency ratio and the bearing capacity of the pile group, as well as the settlement and the distribution of the axial loads of the piles for the safe load on the group (FS=3).

—

by

Computational Geotechnics; Elastic and Elastic-plastic deformation of piles and pile groups Marking scheme: Research & referencing (15%) Analysis (25%) Computer modelling (25%) Results & discussion (25%) Presentation (10%) Coursework brief: Model 1) You are asked to analyse the pile shown in Figure 1, for the parameters shown in Table q, according to the last…

What do you think about the court’s decision to affirm the Board’s ruling to revoke all three certificates?

—

by

Chapter 8 Discussion: Duncan v. Missouri Board Read the case beginning on page 140 and answer the prompt below in 1-2 paragraphs. What do you think about the court’s decision to affirm the Board’s ruling to revoke all three certificates? In light of this case, and similar cases mentioned in the chapter, what are the…

What are the principles behind Value Engineering Change Proposal (VECP)?

—

by